|
Eelectrical Characteristics
|
|
Contact Curren Rating
|
0.5A Min.
|
|
Voltage Rating
|
40V AC (rms)
|
|
Withstanding Voltage
|
500V AC for 1 Min.
|
|
Insulation Resistance
|
100 Megaohms Min.
|
|
Contact Resistance
|
30 mΩ Max.
|
|
Mechanical Characteristics
|
|
Insertion Force
|
44.1 N (4.5kgf) Max
|
|
Withdrawal Force
|
9.8 N (1.0kgf) Min.,3 9.2N( 4.0kgf) Max.
|
|
Durability
|
10000 cycles at 100±50 cycles per hour
|
|
Environmental Characteristics
|
|
Operating Temperature
|
-25ºC to +85ºC
|
|
Test Description
|
Requirement
|
Procedure
|
|
Visual Inspection
|
The inspection results should be compliant with the individual specification
|
Before the qualification test, all these components shall be examined the Features, Construction as per applicable specification and documents
|
Features:
1. With A Type/B Type/C Type and Mini USB variety of types of public Socket Interface Design;
2. Installed in the form of DIP/SMT/clip wire/wire type available;
3. Flexible design of terminal contact area to ensure good contact performance and long life requirements;
4. Meet a variety of welding equipment parameters temperature requirements
Welding conditions:
1. Hand soldering
Use a soldering iron of 30 watts, controlled at 350º C approximately 3 seconds while solder applying.
2. Wave soldering/Reflow Soldering
The peak temperature of the wave oven should be set to 260º C max. Condition for soldering temperature
Material:
1. Housing: PBT White/Black
2. Terminal: Phosphor Bronze Plating Gold/Tin
3. Shell: BRASS Plating Ni
Specification:
Inspection for USB Connector Mechanical Performance
|
Test Description
|
Requirement
|
Procedure
|
|
Terminal / Housing Retention Force
|
0.40kgf /Pin Min.
|
Measure the contact retention
|
|
Insertion Force & Withdrawal Force
|
Insertion Force: 4.50kgf Max.
Withdrawal Force: 1.00kgf Min.
|
The specimen is mounted to mounting fixtures by the normal mounting means. The peak force shall be recorded at the maximum rate of 25mm per minute
|
|
Durability
|
After 10000 cycles test, shall be no evidence of mechanical or electric defects, and shall meet the requirements of connector using.
|
10000 insertion / extraction cycles at a maximum rate of 100±50 cycles per hour.
|
